Table of Contents
Advertisement
Using the system
Setting temperature
A
– Turn the control dial
temperature.
– Turn the control dial
ture.
Controlling blower
– Turn the blower switch
switch the blower on.
– Turn the blower switch
off.
– Pressing the button
switched on - recirculating air mode.
Control for air distribution
– You can adjust the direction of the air flow using the air distribution
A
⇒ page 89.
control
C
Using the system
Safety
Fig. 116 Climatic: Control
elements
⇒ fig. 116
to the right in order to increase the
A
A
to the left in order to increase the tempera-
A
A
into one of the positions, 1 to 4, in order to
B
A
into position 0 in order to switch the blower
B
causes the recirculating air mode to be
Driving Tips
switching cooling on and off
– Press the button
– When you again press the switch
off. The symbol
The set temperature will be automatically maintained other than when the
control dial is on the extreme right or extreme left position:
Extreme right position - full heating.
Extreme left position - full cooling.
A
The controls
and
A
The blower should aways be on to prevent the windows from misting up.
Note
The whole heat output will be needed to unfrost the windscreen and side
windows. No warm air will be fed to the footwell. This can lead to restriction of the
heating comfort.
The used air streams out through the air removal openings in the luggage
compartment.
If the cooling system has not been switched on for a lengthy period, odours may
be produced at the evaporator because of deposits. Switch the air conditioning
system on at least once a month for approximately 5 minutes at the highest blower
stage - also during the cold season of the year - in order to remove such odours.
Also open a window for a short time.
Please refer to the information regarding recirculated air mode ⇒ page 89.
Have the air conditioning system cleaned by a specialist workshop.
General Maintenance
Breakdown assistance
Heating and air conditioning system
. The symbol
in the switch comes on.
AC
, the cooling system is switched
AC
in the switch goes out.
A
can be set to any desired intermediate position.
C
Praktik
93
Technical Data
Advertisement
Table of Contents
