Table of Contents
Advertisement
The variable loading floor makes it easier to handle bulky goods and
creates an even luggage compartment floor when the rear seats are
folded forward. The maximum permissable surface load of the variable
loading floor is 75 kg.
Remove variable loading floor
A
– Unhook the loops
A
the fixing points.
– Unlock the loading floor by turning the locking bolts
⇒ page 74, fig.
180° to the left
– You can fold together the loading floor by moving in the direction of
arrow.
– Lift up the loading floor in direction of arrow
and take out the loading floor by pulling in direction of arrow
⇒ page 74, fig.
83.
Install variable loading floor
– Place the loading floor once folded together onto the carrier rails.
– Fold open the loading floor.
– Lock the loading floor by turning the locking bolts
fig. 82
by approx. 180° to the right.
– Attach the loops of the elastic partition to the fixing points.
WARNING
Pay attention when installing that the carrier rails and the variable loading
floor are correctly fixed, otherwise the occupants are at risk.
Note
If the variable loading floor* is installed, no flexible storage compartment or fixing
nets* can be installed.
Using the system
Safety
⇒ page 74, fig. 82
of the elastic partition out of
A
B
82.
A
⇒ page 74, fig. 83
1
A
⇒ page 74,
B
Driving Tips
Remove carrier rails
by approx.
A
2
Install carrier rails
– Slacken the check point
a flat screwdriver
– Grasp the carrier rail
of arrow. The carrier rail on the other side of the luggage compartment
can be removed in the same way.
Install carrier rails
– Position the carrier rails on the sides of the luggage compartment.
General Maintenance
Breakdown assistance
Seats and Storage
Fig. 84 Luggage compart-
ment: Slacken check points
Fig. 85 Luggage compart-
ment: Remove carrier rails
A
on the carrier rails using the vehicle key or
B
⇒ fig.
84.
A
⇒ fig. 85
and take it out by pulling in direction
A
Praktik
75
Technical Data
Advertisement
Table of Contents
