Using the net partition behind the front seats
Fig. 55 Pull out the net partition/roll up
First read and observe the introductory information and safety warn-
ings
on page 62.
Pulling out
›
Open the rear right door.
›
Fold the seat cushions and rear seat rests forward.
›
Pull the net partition by tab
» Fig. 55
A
brackets
.
C
›
Insert the cross rod into one of the mounts
›
In the same way, insert the cross rod into the mount
vehicle.
Folding
›
First pull the cross rod back slightly on the one side and then on the other side
and remove it from the mounts
C
›
Hold the cross rod in such a way that the net partition can slowly roll up into
the housing
without being damaged.
B
›
Fold the rear seats back into their original position.
out of the housing
in the direction of
B
and push forwards.
C
on the other side of the
C
» Fig.
55.
Removing and refitting the net partition housing
First read and observe the introductory information and safety warn-
ings
on page 62.
Removing
›
Open the rear right door.
›
Fold the seat cushions and rear seat backrests forward – first the left and then
the right backrest.
›
Push the net partition housing
remove it from the mount on the right seat rest in the direction of the arrow
Install
›
Insert the recesses on the net partition housing into the mounts on the rear
seat backrests.
›
Push the net partition housing in the opposite direction of the arrow
as the stop.
›
Fold the rear seats back into their original position.
Bicycle carrier in the luggage compartment
Introduction
This chapter contains information on the following subjects:
Install cross member
Install bicycle carrier
Put bicycle into the bicycle carrier
Secure the stability of the bicycles with a belt
Fig. 56
Rear seats: Net partition hous-
ing
» Fig. 56
in the direction of the arrow
A
Seats and storage
and
1
.
2
as far
1
64
64
65
65
63