Skoda ROOMSTER - 05-2009 Manual page 226

– Open the bonnet.
– For a vehicle with petrol engine remove the activated charcoal filter
system before replacing the bulb in the right front headlight
⇒ fig.
208.
Positions of the light bulbs in the front headlight
A
- low beam and main beam
A
A
- parking lights
B
A
- Turn signal light (at the front)
C
Using the system Safety
Fig. 208 Removing the acti-
vated charcoal filter system
⇒ page 224, fig.
207.
Driving Tips General Maintenance
Switching on the low beam and main beam
– Open the bonnet.
A
– Remove the protective cap
A
– For headlights with module (halogen lamp H7)
connector with the halogen lamp to the left up to the stop and
remove.
– For headlights with reflector (halogen lamp H4) pull off the connector
from the lamp, release the sprung wire clamp and pull out the halogen
lamp towards the rear.
– Replace the halogen lamp H7, insert the connector with the new
halogen lamp and turn to the right up to the stop.
– Replace the halogen lamp H4, insert into the opening in the reflector
(with the fixing lugs in the recesses), secure with the sprung wire
clamp, position the protective cap and mount the connector.
– We recommend that you have the headlight setting checked by a
Skoda Service Partner after replacing the light bulb.
Breakdown assistance
Fuses and light bulbs
Fig. 209 Removing the light
bulb for the low beam and
main beam light
⇒ page 224, fig.
207.
⇒ fig. 209
turn the
Praktik Technical Data
225