Table of Contents
Advertisement
Storing a speed
The cruise control system is operated by means of the switch
A
rocker button
in the left lever of the multi-functional switch.
B
A
⇒ fig. 124
– Press the switch
A
– After the desired speed has been reached, press the rocker button
into the SET- position - the current speed is stored.
After you have released the rocker button
you have just stored is maintained at a constant speed without having to depress
the accelerator.
You can increase the speed by depressing the accelerator. Releasing the acceler-
ator will cause the speed to drop again to the set speed.
This does not apply, however, if you drive at a speed which is more than 10 km/h
higher than the set speed for a period of longer than 5 minutes. The stored speed
will be cancelled in the memory. You then have to re-store the desired speed.
One can reduce the speed in the usual manner. The system is switched off tempo-
rarily by actuating the brake or clutch pedal ⇒ page 106.
Using the system
Safety
Fig. 124 Operating lever:
Rocker button and switch of
cruise control system
A
and
A
into the position ON.
A
out of the position SET-, the speed
B
Driving Tips
General Maintenance
WARNING
First ensure that it is not too high for the traffic conditions which exist at that
moment before resuming the stored speed.
Changing a stored speed
You can also change the speed of the vehicle without depressing the
accelerator.
Faster
– You can increase the stored speed without depressing the acceler-
ator, by pressing the rocker button
tion.
– The speed of the car will increase continuously if you hold the rocker
button pressed in the RES+ position. Once the vehicle has reached
the desired speed, release the rocker button. The set speed is then
A
B
stored in the memory.
Slower
– You can decrease the stored speed by pressing the rocker button
in the SET- position.
– Holding down the pushbutton pressed in the SET- position will cause
the speed of the vehicle to reduce continuously. Once the vehicle has
reached the desired speed, release the rocker button. The set speed is
then stored in the memory.
– If you release the rocker button when the vehicle is travelling at a
speed of less than 30 km/h, the speed is not stored, the memory is
erased. It is then necessary to again store the speed with the rocker
A
button
in the position SET- after an increase in speed of the vehicle
B
to more than 30 km/hour.
Breakdown assistance
Starting-off and Driving
A
⇒ fig. 124
into the RES+ posi-
B
Praktik
Technical Data
105
A
B
Advertisement
Table of Contents
