Table of Contents
Advertisement
62
Lights and Visibility
Attaching a wiper blade
– Position the wiper blade onto the wiper arm and lock the locking
A
button
.
A
– Check whether the wiper blade is correctly attached.
The same remarks apply here as for ⇒ page 61.
Rear mirror
You can adjust the exterior mirrors electrically*.
Adjust the rear mirror before commencing to drive so that there is a clear
view to the rear.
Dimming the interior mirror
– Pull the lever on the bottom edge of the mirror toward rear (the lever
on the interior mirror must point forwards in it home position).
Heating of the external mirror*
– Turn the rotary knob to position
Fig. 59 Inner part of door:
Rotary knob
⇒ fig.
59.
Adjusting the left-hand exterior mirror*
– Turn the rotary knob to position
is identical to the movement of the rotary knob.
Adjusting the right-hand exterior mirror*
– Turn the rotary knob to position
surface is identical to the movement of the rotary knob.
The vehicle can also be equipped with a second rear mirror*, which is attached
above the inner main rear mirror. The second rear mirror* enables an extensive
look into the area of the rear seats, e.g. to check on the seated passengers. You can
adjust it in the horizontal as well as vertical direction regardless of the inner main
rear mirror.
The exterior mirror heater only operates when the engine is running.
WARNING
Convex (curved outward) or spherical (differently curved) exterior
mirrors increase the vision field. They do, however, make objects appear
smaller in the mirror. These mirrors are only of limited use, therefore, for
estimating distances to the following vehicles.
Use whenever possible the interior rear mirror, for estimating the
distances to the following vehicles.
Note
Do not touch the surfaces of the exterior mirrors if the exterior mirror heater is
switched on.
You can set the exterior mirrors by hand, if the power setting function fails at any
time by pressing on the edge of the mirror surface.
Contact your specialist garage if a fault exists with the power setting of the exte-
rior mirrors.
. The movement of the mirror surface
. The movement of the mirror
Advertisement
Table of Contents
