NOTE: Make sure that the exhaust filter is always properly locked into position, otherwise the exhaust air
will not be properly filtered.
Changing the Motor Protection Filter
1. Switch the vacuum cleaner off and remove the dust filter bag as described in the section "Changing the
Dust Filter Bag," steps 1 thru 4.
2. Remove the filter holder with the motor protection filter. Slightly press down on the top tabs and then
pull the filter cover forwards and out.
3. Remove the motor protection filter from the filter holder over a dustbin.
4. Clean the filter holder with warm soapy water and let it air dry.
5. If the new motor protection filter is too large, lay the old filter onto the new filter mat. Mark the
contours and cut the new filter down to size with a pair of scissors.
6. Insert the new motor protection filter into the filter holder.
7. Insert the filter holder with the new filter into its bracket from above and push it down until it audibly
locks into place.
8. Replace the dust bag - close the dust bag compartment cover. The cover clicks into place audibly.
26
Need help?
Do you have a question about the Phantom and is the answer not in the manual?