Safety Features - Xerox Document Centre 50 User Manual

The Document Centre ColorSeries 50 copier/
printer is equipped with a safety feature called a
Ground Fault Protector, Figure 18. This device
removes all electrical power to the copier/printer if
a fault is detected in the power supply to the
copier/printer.
2
If power is interrupted to the copier/printer,
2
perform the following:
1
Locate the Ground Fault Protector on the back of
3
the copier/printer in the lower left corner.
2
If the device has tripped, the switch will be in the
Off (down) position. Flip the switch up to restore
power.
If the device interrupts power to the copier/printer
again, or if power has not been restored by the
above procedure, call your Xerox service
4
representative.
CAUTION: The Fuser Roll remains in a cammed-
up position if power to the copier/printer is
interrupted while the copier/printer is in use. If the
Fuser Roll remains in the cammed-up position for
a prolonged period of time, the Fuser Roll can be
damaged and copy quality defects can occur. To
prevent any damage, the copier/printer should be
5
powered on and a copy/print made as soon as the
power is restored. The Fuser Roll will not be
released from the cammed-up position until the
power is restored, the Power Switch is in the On
position, and the Start button is pressed again.
6
7
GETTING TO KNOW YOUR COPIER/PRINTER

Safety Features

Figure 18: Ground Fault Protector
2–22 DOCUMENT CENTRE CS 50 USER GUIDE