Xerox Document Centre 50 User Manual page 38

4 Energy saver button - Press this button to initiate
the Enerfy saver mode. The Document Centre
ColorSeries 50 will also go into Energy saver
mode automatically if it is not used for a length of
time specified by the System Administrator in the
Tools Mode.
The Energy saver mode enables the Document
Centre ColorSeries 50 to use less power than
when it is in Ready mode. Press the Energy
2
saver button again to bring the copier/printer into
2
a warm-up cycle.
5 Interrupt - Press this button to stop the copier/
printer during the copy process. The copier/printer
completes the in-progress copy job. Once the
copy job is completed, interrupt occurs and the
interrupt job may be started. There are two
indications the job has been interrupted:
3
•
•
4
After all interrupting jobs have been completed,
press the Interrupt button again to exit the
Interrupt mode and return to the first job.
NOTE: Interrupt should not be used when the
machine is in a fault condition, except for Image
5
Quality faults, alerts, or when a message indicates
the job is incomplete. You also can not use the
Interrupt button with the following features:
•
•
•
6
7
GETTING TO KNOW YOUR COPIER/PRINTER
The copier/printer displays a message
indicating that Job Interrupt has been
selected, and it is ready to copy.
The indicator light flashes to acknowledge that
the Interrupt button has been pressed. It
continues to flash until the copier/printer
interrupts the job in process. When the
Interrupt indicator light is on continuously (not
flashing), a new job can be programmed.
Multiple-Up
Auditron Access
Tools Mode
2–4 DOCUMENT CENTRE CS 50 USER GUIDE