Xerox Document Centre 50 User Manual page 167

1 Touch the Transparency Separators button on
the Output Formats tab to display the
Transparency Separators screen (Figure 16).
2
Touch one of the following options:
•
No Separators (default setting, Figure 16)
•
Blank Separators (Figure 17)
– Ensure that the Paper Tray listed for the
separators contains the correct size and
type of paper.
– If you need to make changes to the
separator paper tray, touch the Paper
Trays button to display the Tray Settings
screen (Figure 18). Notice that only Paper
Tray 5 is selectable as the transparency
tray.
– You may have to touch the Tray 5 button
and select a Paper Type (Transparency)
and size before the system allows you to
save these values and select a Separator
Tray.
– Under Separator Tray, select the paper
tray to use as a source for the separators.
– Touch Save to return to the Transparency
Separators screen.
3 Touch Save to display the Output Formats tab.
KEY POINT: If you load transparencies into Tray
5, it is automatically set to transparencies. The
Tray 5 window does not pop up like it does when
separators are selected.
DOCUMENT CENTRE CS 50 USER GUIDE
Figure 16: Transparency Separators screen
Figure 17: Transparency Separators screen
with Blank Separators selected
Figure 18: Tray Settings screen
7–13
1
2
3
4
5
6
7
OUTPUT FORMATS