Suitable For Use; Warnings - Britax CONVERTIBLE CHILD RESTRAINT WITH AHR Instructions For Installation And Use Manual

TO BE USED WITH A LAP SASH OR LAP ONLY SEAT BELT
IN THE FRONT OR BACK OF MOST CARS WITH FORWARD-
FACING SEATS.
The purchaser should check the measurements between the front of the seat back of the rear seat and all front seats in the car in
which the child restraint is intended to be used, to ensure that the space is sufficient.
In certain vehicles, where the rear seat is too small, the only position possible for the restraint is the front seat adjusted as
rearward as possible.
DO NOT USE RESTRAINT IN REARWARD FACING MODE WITHOUT STABILISING BAR FULLY EXTENDED.
Do not use the restraint without the Upper Anchorage Strap correctly attached.
DO NOT USE A REAR FACING CHILD RESTRAINT WHERE AN AIRBAG IS FITTED IN FRONT OF THE SEATING POSITION.
Do not use the baby insert after baby reaches 10kg and over.
When using the restraint in the front seat, do not use the rear seat. The upper anchorage strap will need to pass the rear seating
position to attach to an anchorage point.
Do not use on any vehicle seat which faces sideways or rearwards.
Never leave babies or toddlers in a stationary car in the sun because of the
risk of heat exhaustion.
Ensure babies and toddlers have adequate ventlation and are shaded from
direct sunlight through side or rear windows.
FOR BABY USE (BIRTH TO 12kg)

SUITABLE FOR USE

To be used only in a rearward-facing position for a child
weighing up to 12 kg.
Do not allow the front seat to alter
the installed position of the restraint

WARNINGS

7