How To Use - Britax CONVERTIBLE CHILD RESTRAINT WITH AHR Instructions For Installation And Use Manual

PLACING BABY INTO RESTRAINT
A. Ensure the headrest and shoulder straps are adjusted to the correct height for your child (see page 8).
B. Slacken the Upper Anchorage Strap and allow the straps to fall to the sides of the restraint for easy access
to the baby.
C. Slacken Harness Straps by pushing and holding the Harness Adjustment Button, grasping BOTH shoulder
harness straps and pulling out the desired amount of slack. Release harness adjustment button when there
is enough slack and place harness to each side of the restraint.
D. Lay baby on their back into restraint and fit harness as shown above. Make sure the baby is dressed to
allow harness buckle to be pulled up between baby's legs e.g. a jump suit. Make sure the baby's arms and
legs are free. Never wrap baby in a blanket before placing in restraint.
Adjustable
Headrest
Adjuster for the Upper
Anchorage Strap
E. Fit either harness tongue into the harness buckle followed by the other tongue until a click is heard. Should
the second tongue not insert, press the red button and reinsert the tongues. Ensure secure engagement by
pulling harness straps.
Tongue
Buckle
F. Remove slack from harness lap straps by pulling shoulder straps.
Slackened Upper
Harness
Baby Insert
Anchorage Strap
shoulder
straps
Click
FOR BABY USE (BIRTH TO 12kg)

HOW TO USE

Harness
Adjustment
Button
Adjuster Strap
(Where Fitted)
Pull to remove slack
from Harness Lap Straps
Shoulder
Straps
Harness Lap
Straps
Crotch Straps
13