Britax CONVERTIBLE CHILD RESTRAINT WITH AHR Instructions For Installation And Use Manual page 20

FOR CHILD USE (8 to 18kg)
HOW TO INSTALL
INSTALLING INTO VEHICLE (FORWARD FACING)
(UPRIGHT OR RECLINED)
J. Fit the attachment clip to the anchor fitting as shown. Make sure to remove as many twists as possible from
the upper anchorage strap.
K. Tighten Adjustable Upper Anchorage Strap by pulling adjustment strap to remove slack as shown below,
but do not over-tighten causing the restraint base to lift off the vehicle seat. Fold up excess strap and use
storage strap to neatly store excess strap away from child's reach.
SEAT BELT 'LOCK OFF' (WHERE FITTED)
If seat belt 'lock-off' is fitted, follow steps above, through to point K. Press the seat belt 'lock off' while threading the sash part of
the seat belt through the slot in the 'lock off', then release the 'lock off' (refer to illustration below).
Push restraint firmly downward, while pulling sash part of seat
belt to tighten through 'lock off'. This will prevent the seat belt
loosening.
IMPORTANT: Always roll up the excess Upper
anchorage Strap.
20
Press to engage
lock fully
Front of vehicle
Attachment
Clip & Cover
Upper Anchorage
Upper Anchorage
Strap
Adjustment Strap
Storage Strap
Anchor
fitting
Attachment
Clip & Cover
Pull to
remove
slack
Anchor
Fitting
Seat Belt
'Lock Off'
Child use
seat belt path