Britax CONVERTIBLE CHILD RESTRAINT WITH AHR Instructions For Installation And Use Manual page 11

F. Align restraint centrally to the chosen seating position as shown below. Pull sash portion of seat belt until all
slack is removed from Lap portion of seat belt. Adjust seat belt to hold the restraint firmly against the vehicle
seat back. For retractor seat belts, allow excess belt to feed back into retractor.
Lock the rear facing seat belt lock-off (where fitted) to prevent the seat belt slackening.
Fully press Adjuster Button (A) while pulling
Upper Anchorage Strap (B) to lengthen.
G. Fit the attachment clip to the anchor fitting as shown above right. Make sure to remove as many twists as
possible from the upper anchorage strap.
H. Tighten adjustable upper anchorage strap by pulling adjustment strap to remove slack, but do not
over- tighten causing the restraint base to lift off the vehicle seat.
This will usally be done once the baby has been harnessed into the seat.
A single twist is
required in baby
use.
Do not use this slot for
baby use installation
Front of vehicle
WARNING:
DO NOT USE RESTRAINT IN REARWARD FACING MODE WITHOUT STABILISING
BAR FULLY EXTENDED.
THE UPPER ANCHORAGE STRAP MUST ALWAYS BE FITTED WHEN THE CHILD RESTRAINT IS
USED IN A VEHICLE.
FOR BABY USE (BIRTH TO 12kg)
A
Storag e
Strap
Ensure Upper Anchorage Strap is
tightened, attached to the Anchor Fitting
and that straps are the same length on
both sides of
Attachment Clip.
Pull sash portion of seat belt to remove
slack.
Feed seat belt between restraint cover
and restraint body. (see previous page.)
Engage the Lock-offs (if fitted) to
prevent the seat belt slacking.
Do not use the Lock-off if the seat buckle interferes.
HOW TO INSTALL
B
Pull Adjustment Strap
to remove slack
11