How To Install - Britax CONVERTIBLE CHILD RESTRAINT WITH AHR Instructions For Installation And Use Manual

FOR BABY USE (BIRTH TO 12kg)

HOW TO INSTALL

A. Unhook hook & loop attachments & gently lift the cover, fully
extend out stabilising bar and gently push bar forward until a
click is heard. Stabilising Bar is now latched in place.
Note: Do not re-attach cover hook & loop until you have
installed seat belt.
B. Position restraint rearward facing in the chosen seating
position.
C. Fully lengthen seat belt and feed the seat belt between the
restraint cover and the restraint body through seat belt
slots in restraint. Place the seat belt under any comfort foam.
D. Engage seat belt buckle & tongue.
Note: Seat belt buckle and tongue must not rest between restraint cover and restraint. If seat belt buckle is
adjustable, adjust buckle as low as possible away from the restraint.
E. Re-attach hook and loop attachments.
Hook and loop
attachments
10
Do not use this slot for
baby use installation
On the opposite
side to the seat belt
buckle, only pass
the lap portion of
the belt through the
lock-off and lock in
place.
Click
Place the seat belt under any
foam padding that is supplied
with the restraint.
Hook and loop
attachments
On the car seat belt
buckle side, pass
both lap and sash
seat belt through the
lock-off and lock in
place
Push bar
Pull out
forward.
Stabilising
Bar.
Rear facing seat
belt lock-off
(if fitted)