Britax CONVERTIBLE CHILD RESTRAINT WITH AHR Instructions For Installation And Use Manual page 12

FOR BABY USE (BIRTH TO 12kg)
HOW TO INSTALL
Important: If using an Extension Strap, positioning the Attachment Clip above the baby may lead to injury in an accident therefore
make sure that the Attachment Clip is not positioned in front of the vehicle seat.
ANGULAR ADJUSTMENT OF RESTRAINT
Some vehicle seats have more rearward slope than others. If the angle of the seat causes the baby to be too upright for comfort,
the angle may be altered by placing a firm packing between the seat and the underside of the base. Packing can be a firmly rolled
up towel or nappy.
Do not remove all of the rearward slope by over packing. Always leave a rearward slope angle of approximately 10 to 15 degrees
as shown
TO REMOVE RESTRAINT FROM VEHICLE
A. Disengage seat belt tongue from buckle and remove from restraint.
B. Fully press Upper Anchorage Strap Adjuster Button (A) while pulling Upper
Anchorage Strap (B) to slacken as shown right. In some vehicles loosening of the
Upper Anchorage Strap may be difficult. If so, try pushing the restraint against the
vehicle seat back or slightly lifting the restraint to release the tension.
C. Disengage Attachment Clip from Anchor Fitting. The child restraint is now
disconnected.
12
Front of
vehicle
10 to15
Attachment Clip should not be in
front of the vehicle seat front.
Attachment
Clip
Fully press Adjuster Button (A)
while pulling Upper Anchorage
Strap (B) to lengthen.
Storage
Strap
Attachment Clip should be
behind the front of the vehicle
seat front.
Extension
Strap
A
B
Pull Adjustment Strap
to remove slack