Page 1
Series number: 25/C/2004 & 25/D/2004 Convertible Child restraint for vehicle use. Rearward Facing For use with children up to 12kg. Forward Facing. For use with children from 8kg up to 18kg. INFORMATION FOR BUYERS: FOR USE WITH CHILDREN FROM BIRTH TO 18 KG. CHECK THAT THIS CHILD RESTRAINT WILL FIT IN YOUR CAR.
Refer to Catalogue. WHO TO CONTACT AUSTRALIA NEW ZEALAND Britax Childcare Pty. Ltd. A Britax International company. Britax Childcare NZ Limited. A Britax International company. (Incorporated in Victoria) A.C.N. 006 773 600 A.B.N 55 006 773 600. PO Box 100-247 Auckland 9 Phone: (09) 443 0102...
FOLLOW THESE INSTRUCTIONS EXACTLY. In the event of doubt about the method of installation, consult Britax Childcare or agent or a child restraint fitting station authorised by the relevant transport authority or in New Zealand, the agent for the vehicle. Use only Safe-n-Sound recommended parts and accessories, which are available from most Safe-n-Sound retailers (refer to page 24 for accessories).
HOW TO INSTALL Consult the vehicle owner's handbook for location of anchor fittings or anchorage points and the possible use of spacers. Some vehicles may have an anchor fitting fitted by the vehicle manufacturer. If anchorage points cannot be found refer to car manufacturer or local child restraint fitting station or traffic authority for optimum position of anchorage point and the use of spacers.
Page 5
HOW TO INSTALL ANCHOR FITTING: WARNING: CHILD RESTRAINTS MUST NOT BE ATTACHED TO UNSOUND METAL OR TO WOOD, OR SYNTHETIC STRUCTURES. WHEN DRILLING 9 MM HOLE DO NOT DRILL THROUGH FUEL LINES, FUEL TANKS, ELECTRICAL WIRING, OR RADIO SPEAKERS. WEBBING STRAPS MUST BE PROTECTED FROM SHARP CORNERS AND EDGES.
Page 6
HOW TO INSTALL Important: If using an Extension Strap, positioning the Attachment Clip above the baby may lead to injury in an accident Attachment Clip must Attachment Clip must therefore make sure that the Attachment not be in front of the be behind the front of Clip is not positioned in front of the vehicle the vehicle seat.
Page 7
SPECIAL FEATURES FOR BABY USE Front of vehicle Padded cover for baby’s comfort. Padded insert for extra comfort. (If supplied) Adjustable Upper Anchorage Strap. Harness Adjuster Lock. (Under flap) Stabilising Bar for baby use. Attachment Clip & Cover. Anchor Fitting. Harness Adjustment Strap.
SUITABLE FOR USE BABY TO BE USED WITH A LAP-SASH OR LAP ONLY SEAT BELT IN THE FRONT OR BACK OF MOST CARS WITH FORWARD-FACING SEATS. To be used only in a rearward-facing position for a child weighing up to 12kg. Up to 12 kg Facing Rearward The purchaser should check the measurements between the front of the seat back of the rear seat and...
HOW TO SET-UP SETTING UP THE HARNESS Sit the restraint on a flat ground and supported from behind so that it will not tip over. Get the child to sit comfortably in position. Determine the desired shoulder strap position. Remove the child and adjust the shoulder straps using the following methods. Repeat steps A-C to confirm the correct set-up of the built-in harness.
HOW TO SETUP BABY STEPS IN CHANGING SHOULDER STRAP SLOTS Remove the restraint from vehicle as instructed on page 6. At the rear of the restraint, remove one of the harness ulder straps from metal Strap Connector by slipping strap through open slot.
HOW TO INSTALL COMPAQ DELUXE COMPAQ For baby use, you must first Move Recline Foot by grasping Foot, pressing the Recline Foot Locking Bar fully recline the restraint, to while rotating to the baby position convert the restraint to baby use (refer to label on the side of the mode as shown below.
Page 12
HOW TO INSTALL BABY Ensure all slack is removed from Upper Anchorage Strap. Pull sash portion of seat A single twist belt to remove slack from is required for lap portion of belt. easy access to the Upper Anchorage Feed seat belt between Ensure seat is in Adjuster.
HOW TO USE PLACING BABY INTO RESTRAINT CROTCH STRAP POSITION - BABY USE The crotch straps must be in the inner position to accommodate the smaller child. Refer to page 23 (Care & Maintenance) instructions and follow point A. Ensure both crotch straps are in the inner position as shown right.
HOW TO USE BABY Pull to remove slack Pull lap and crotch straps firmly. Pull shoulder from Harness Lap Straps harness straps to remove slack from harness lap straps. Pull harness adjustment strap to take up the slack Shoulder in the harness adjusting to a comfortable but firm Straps fit.
Page 15
SPECIAL FEATURES FOR CHILD USE To be used only in a forward-facing position for a child weighing from 8 kg to 18 kg. Harness Tongues Harness Buckle Front of vehicle Upper Anchorage Strap Adjuster. Upper Anchorage Strap. Adjustable Upper Anchorage Strap.
SUITABLE FOR USE To be used only in a forward facing TO BE USED WITH A LAP-SASH OR LAP ONLY position for a child weighing from SEAT BELT IN THE FRONT OR BACK OF MOST 8 kg to 18 kg. CARS WITH FORWARD-FACING SEATS.
Page 17
HOW TO SETUP ADJUSTING SHOULDER HARNESS STRAPS HEIGHT FOR CHILD USE FORWARD-FACING Correct fitment of the harness is very important as it restrains the child in the restraint. The harness must fit firmly around the upper torso of the child and be positioned so as to leave the child's arms and legs free.
HOW TO INSTALL INSTALLING INTO VEHICLE (FORWARD FACING) (UPRIGHT OR RECLINED) DO NOT USE RESTRAINT IN FORWARD-FACING MODE WITH THE STABILISING BAR PULLED OUT. If the Stabilising Bar is extended Press blue button on left side (facing seat) unhook Hook and Loop attachments and gently push stabilising bar all the way and push trim away from restraint.
Page 19
HOW TO INSTALL COMPAQ DELUXE COMPAQ Place one hand on the front of base Move Recline Foot by grasping firmly, while with the other hand push the Foot, pressing the Locking the blue recline latch up to unlock and Bar while rotating to the required...
Page 20
HOW TO INSTALL Engage seat belt buckle and tongue, ensure to remove all slack from lap part of seat belt by pulling sash belt. Adjust the seat belt to hold the restraint firmly against the vehicle seat. For inertia/retractable seat belts, Attachment allow excess belt to feed back into Clip &...
Page 21
HOW TO USE PLACING CHILD IN THE RESTRAINT Outer Crotch Strap Position CROTCH STRAP POSITION - CHILD USE The crotch straps must be moved to the outer position to accommodate the larger child. Refer to page 23 (Care & Maintenance) instructions and follow point A.
Page 22
HOW TO CLEAN The restraint has a flame retardant cover which is removable for cleaning. Cleaning instructions are on the care label attached to the cover. If fluffy cover is fitted then washing cover prior to use will remove excess fluff. Ensure that the inside of the buckle is free of foreign matter.
Page 23
CARE & MAINTENANCE REGULAR CARE OF THIS RESTRAINT: Please check the following items regularly to ensure the safety of your child: Check the webbing for fraying. Check that the buckle clicks and is not sluggish or sticky in operation. Ensure there are no cracks in moulding or the plastic moulding. Check the Harness Adjuster is operating and is clamping the webbing.
Page 24
ACCESSORIES & FEATURES The following instructions apply to accessories that may be supplied with this restraint at point of purchase. If not, a variety of accessories are available from various retailers of safe- n-sound products. In the case of a small baby, accessories are available to improve the installed position of the baby in the restraint.
Page 25
ACCESSORIES & FEATURES HOOD Hooks The hood has been designed to protect your child from direct sunlight when fitted in the forward-facing position. Attach the elastic straps at the back of the hood to the hooks at the rear of the restraint. Attach together the press stud on the ends of the hood &...
Page 26
TRAVELLING TIPS SAFETY CLOTHING/BATHING Never hold a baby or a child in arms when Take several changes of clothing and bibs riding in a motor vehicle. In this position for possible car sickness. the baby or child could be thrown against the Disposable nappies and liners are very dashboard, windscreen or other occupant handy while travelling.
This notice is to advise you of the requirements of the Australian/New Zealand Standards and our obligation in complying with the standards. Please assist the owner of this restraint in their claim. Britax Childcare Pty. Ltd. (Incorporated in Victoria) A.B.N 55 006 773 600...
Page 28
We reserve the right to alter this product without notice in our constant endeavour for improvement. 1997-2006 Britax Childcare Pty. Ltd. This product is covered by Australian and overseas patent applications. Patents Pending. Visit the Britax Web Site at http://www.britax.com.au or Email us at: custserv@britax.com.au...