Ricoh FAX5510L Operating Instructions & Basic Features page 49

❖ ❖ ❖ ❖ Extra Super Fine (24× × × × 23.1 lines/mm,
600× × × × 600dpi)(When receiving a fax
message or copying, Optional 40MB
Memory Card is required.)
This is suitable for originals with
small characters or geometric fig-
ures like newspapers.
Select when you require finer im-
age clarity than super fine.
Limitation
❒ If the other party's machine does
not support the resolution at which
you are sending, this machine au-
tomatically switches to a resolution
which is supported. This machine
can send with Standard, Detail,
Super Fine and Extra Super Fine.
Even if you send the original with
Extra Super Fine, the other party's
machine may receive it with Fine
(8x15.4lines/mm, 200x400dpi) or
Detail (8x7.7lines/mm, 200x200dpi).
❒ When copying or receiving with
Extra Super Fine, Optional 40MB
Memory Card is required. Turn
th e "E XT R A SU PE R FI NE IN
COPY MODE" and "EXTRA SU-
P E R F I N E I N R E C E P T I O N
MODE" on with the User Parame-
ters (switch 20 bit 1 and bit 3). See
p.178 "User Parameters", <Ad-
vanced Features>.
❒ When sending with Extra Super
Fine, turn the "EXTRA SUPER
FINE IN TRANSMISSION MODE"
o n with the User Parameters
(switch 20 bit 2). See p.178 "User
Parameters", <Advanced Features>.
Note
❒ This machine can receive fax mes-
sages with Standard, Detail, Su-
p e r F i n e , E x t r a S u p e r F i n e
(option).
❒ You can check the resolution type
with the Journal.
❒ When receiving fax messages or
printing reports and lists, or copy-
ing with Extra Super Fine (option),
the "Length Reduction"function
cannot be used.
❒ When turning the "EXTRA SUPER
FINE IN TRANSMISSION MODE"
and "EXTRA SUPER FINE IN RE-
CEPTION MODE" on with the
user parameters (switch 20 bit 2,3),
sending or receiving faxes on mul-
tiple lines is not possible. Copies
and received documents cannot be
printed either.
❒ To select 300x300dpi, NIC FAX
Unit (Option for Type1) is re-
quired. 300x300dpi can be used
with the scanner function. When
s e n d i n g f a x m e s s a g e s w i t h
300x300dpi, the machine switches
to Detail automatically.
❒ You can set the resolution type af-
ter the power is turned on or the
{ { { { Clear Modes / Energy Saver} } } } key is
pressed with the user parameters
(switch 00 bit 5,4). See p.178 "User
Parameters", <Advanced Features>.
A A A A
Press the { { { { Resolution} } } } key to
switch between resolutions. The
indicators above the key show the
current selection.
Note
❒ When Detail and Super Fine
a r e l i t a t t h e s a m e t i m e ,
300x300dpi (option) is selected.
Scan Settings
2
43