Dell PowerEdge HX574 Hardware Owner's Manual page 41

Table 1-8. System Messages (continued)
Message
This system
supports only
Opteron n series
processors.
Time-of-day clock
stopped
Time-of-day not
set - please run
SETUP program
Timer chip counter
2 failed
TPM failure
Unsupported CPU
combination
Unsupported CPU
stepping detected
Utility partition
not available
Causes
Microprocessor(s) is not
supported by the system.
Faulty battery or faulty
chip.
Incorrect Time or Date
settings; faulty system
battery.
Faulty system board.
A Trusted Platform
Module (TPM) function
has failed.
Microprocessor(s) is not
supported by the system.
The <F10> key was
pressed during POST, but
no utility partition exists
on the boot hard drive.
Corrective Actions
Install a supported
microprocessor or
microprocessor
combination. See
"Installing a Processor" on
page 103.
See "Troubleshooting the
System Battery" on
page 155.
Check the Time and Date
settings. See "Using the
System Setup Program" on
page 45. If the problem
persists, replace the system
battery. See "System
Battery" on page 117.
See "Getting Help" on
page 181.
See "Getting Help" on
page 181.
Install a supported
microprocessor or
microprocessor
combination. See
"Installing a Processor" on
page 103.
Create a utility partition on
the boot hard drive. See the
CDs that came with your
system.
About Your System
41