Troubleshooting External Connections; Troubleshooting The Video Subsystem - Dell PowerEdge HX574 Hardware Owner's Manual

Troubleshooting External Connections

Loose or improperly connected cables are the most likely source of problems
for the system, monitor, and other peripherals (such as a printer, keyboard,
mouse, or other external device). Ensure that all external cables are securely
attached to the external connectors on your system. See "Front-Panel
Features and Indicators" on page 13 and "Back-Panel Features and Indicators"
on page 18 for the front- and back-panel connectors on your system.

Troubleshooting the Video Subsystem

Problem
• Monitor is not working properly.
• Video memory is faulty.
Action
1 Check the system and power connections to the monitor.
2 Determine whether the system has an expansion card with a video output
connector.
In this system configuration, the monitor cable should normally be
connected to the connector on the expansion card, not to the system's
integrated video connector.
To verify that the monitor is connected to the correct video connector,
turn off the system and wait for 1 minute, then connect the monitor to the
other video connector and turn the system on again.
3 Determine whether the system has monitors attached to both the front
and back video connectors.
The system supports only one monitor attached to either the front or back
video connector. When a monitor is connected to the front panel, the
back-panel video connector is disabled.
If two monitors are attached to the system, disconnect one monitor. If the
problem is not resolved, continue to the next step.
4 Run the appropriate online diagnostic test. See "Using Dell PowerEdge
Diagnostics" on page 169.
If the test runs successfully, the problem is not related to video hardware.
Troubleshooting Your System
147