Dell PowerEdge HX574 Hardware Owner's Manual page 28

Table 1-7. LCD Status Messages (continued)
Line 1 Line 2
Message Message
E1812 HDD ##
Removed
E1914 DRAC5 Conn2
Cbl
E1A14 SAS Cable A
E1A15 SAS Cable B
E1A1C LOM Mezz
Missing
E2010 No Memory
E2011 Mem Config
Err
E2012 Unusable
Memory
28
About Your System
Causes
Specified hard drive has
been removed from the
system.
DRAC 5 cable is missing
or unseated.
SAS cable A is unseated,
missing, or bad.
SAS cable B is unseated,
missing, or bad.
NIC daughter card is
missing.
No memory is installed in
the system.
Memory detected, but is
not configurable. Error
detected during memory
configuration.
Memory is configured,
but not usable. Memory
subsystem failure.
Corrective Actions
Information only.
Reconnect the cable. See
"RAC Card" on page 86.
Check the cable
connection to the SAS
backplane. See "SAS
Backplane Board
Connectors" on page 178.
Check the cable
connection to the SAS
backplane. See "SAS
Backplane Board
Connectors" on page 178.
Install or reseat the NIC
daughter card.
Install memory modules.
See "System Memory" on
page 94.
Check the memory
configuration and
reinstall the memory
modules if necessary. See
"System Memory" on
page 94.
See "Troubleshooting
System Memory" on
page 158.
See "Troubleshooting
System Memory" on
page 158.