ST STM32Cube Quick Start Manual page 50

• As for the standalone mode, to enable the automode you must
set up the automode component properly in the
device_config.json:
•
enabled: if true, the automode starts after the reset and node initialization. If
false, automode is not executed.
•
nof_acquisitions: gives the number of times the automode is executed; zero
indicates an infinite loop and it is the default value.
•
start_delay_s: indicates the initial delay in seconds applied after reset and
before the first execution phase starts.
•
logging_period_s: specifies the duration in seconds of the datalog phase.
•
idle_period_s: specifies the duration in seconds of the idle phase.
• c_type: describes the component type (0 "sensor", 1 "algorithm", 2 "other").
• Then place it in the root folder of the SD card.
• If the board is battery-powered and switched off, press the
PWR button to switch on the board. Press the RESET button.
Automode
50