Removing The Sas Raid Controller Daughter Card - Dell POWEREDGE 1900 Hardware Owner's Manual

Figure 3-25. Replacing a SAS RAID Controller Daughter Card Battery
7
6
5
4
1 connector release tab
4 expansion-bay bracket
7 SAS RAID controller daughter
card

Removing the SAS RAID Controller Daughter Card

1 If applicable, disconnect the RAID battery cable from the controller card by releasing the tab on the
cable connector on the SAS RAID controller daughter card and disconnecting the battery cable. See
Figure 3-26.
2 Remove the hard drive LED activity cable from the SAS RAID controller daughter card.
3 Push outward on the plastic guide rails and gently pull up on the card edges until the card-edge
connector clears the socket on the system board. See Figure 3-26.
9
8
3
2 routing hole for RAID battery
cable
5 battery bay
8 hard drive LED activity cable
1
2
3 RAID battery cable
6 RAID battery
9 hard drive LED activity cable
connector
Installing System Components
93