Installing An Internal Scsi Tape Backup Unit - Dell POWEREDGE 1900 Hardware Owner's Manual

Figure 3-15. Installing and Removing the Half-Height Tape Backup Unit or Optical Drive
1 SCSI ribbon cable
4 peripheral bay

Installing an Internal SCSI Tape Backup Unit

This subsection describes how to configure and install an internal SCSI tape backup unit.
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical
outlet.
2 Remove the front bezel, if attached. See "Removing the Bezel" on page 46.
3 Open the system. See "Opening the System" on page 48.
68
Installing System Components
5
2 power cable
5 half-height tape backup unit or
optical drive
1
2
3
4
3 release latch