Removing the LSI 2008 SAS mezzanine card
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: The LSI 2008 SAS mezzanine card is seated in PCI-E Gen3 x8 mezzanine slot 3 on the
system board, which is not active in 1-processor configuration.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Turn off the system, including any attached peripherals.
3.
Disconnect the system from the electrical outlet and disconnect the peripherals.
4.
Remove the system board assembly.
1.
Disconnect all the cables from the mezzanine card.
2.
Remove the screws that secure the LSI 2008 SAS mezzanine card.
3.
Lift the mezzanine card out of the system-board assembly.
Figure 28. Removing and installing the LSI 2008 SAS mezzanine card
1.
LSI 2008 SAS mezzanine card
3.
bridge card
2.
screw (3)
63