Dell POWEREDGE 1900 Hardware Owner's Manual page 96

7 Disconnect the control panel cable from the back of the control panel. See Figure 3-27.
NOTICE:
Do not pull on the cable to unseat the connector. Doing so can damage the cable.
Squeeze the metal tabs on the ends of the cable connector.
a
Gently work the connector out of the socket.
b
8 Remove the display module:
Insert the end of a paper clip into the hole on the right side of the display module and gently
a
pry the label off.
Using a T10 Torx driver, remove the two screws that secure the display module to the system
b
chassis.
Remove the display module from the chassis cutout.
c
Figure 3-27. Removing the Control Panel Assembly
1 screws (3)
4 system chassis
7 display module screws (2)
96
Installing System Components
2
1
2 control panel board
5 display module cable
8 display module label
3
5
6
7
8
3 control panel cable
6 display module
4