Integrated Devices Screen; Serial Communication Screen - Dell POWEREDGE 1900 Hardware Owner's Manual

Integrated Devices Screen

Table 2-4 lists the options and descriptions for the information fields that appear on the Integrated
Devices screen.
Table 2-4. Integrated Devices Screen Options
Option
Integrated SAS Controller
(Enabled default)
Integrated RAID
Controller
(Enabled default)
Embedded SATA
(Off default)
IDE CD-ROM Controller
(Auto default)
Diskette Controller
(Auto default)
User Accessible USB Ports
(All Ports On default)
Embedded Gb NIC
(Enabled with PXE
default)
MAC Address
TOE Capability

Serial Communication Screen

Table 2-5 lists the options and descriptions for the information fields that appear on the Serial
Communication screen.
Table 2-5. Serial Communication Screen Options
Option
Serial Communication
(Off default)
38
Using the System Setup Program
Description
Enables or disables the integrated SAS controller. This option appears only if a SAS
controller is installed.
Enables or disables the integrated RAID controller. This option appears only if a
SAS RAID controller is installed.
Allows the integrated SATA controller to be set to Off or ATA Mode.
Enables the integrated IDE controller. When set to Auto, each channel of the
integrated IDE controller is enabled if IDE devices are attached to the channel.
Enables or disables the system's diskette drive controller. When Auto is selected,
the system turns off the controller when necessary to accommodate a controller
card installed in an expansion slot. You can also configure the drive as Read-Only,
or Off. When using the Read-Only setting, the drive cannot be used to write to a
disk.
Enables or disables the system's user accessible USB ports. Options are All Ports
On, Only Back Ports On, and All Ports Off.
Enables or disables the system's integrated NIC. Options are Enabled without
PXE, Enabled with PXE, and Disabled. PXE support allows the system to boot
from the network. Changes take effect after the system reboots.
Displays the MAC address for the integrated 10/100/1000 NIC. This field does not
have user-selectable settings.
Displays the TCP/IP Offload Engine (TOE) feature status of NIC.
Description
Options are On with Console Redirection via COM2, and Off.