Dell POWEREDGE 1900 Hardware Owner's Manual page 18

Table 1-4. LCD Status Messages (continued)
Code Text
E1414 CPU # Thermtrip
E1418 CPU # Presence
E141C CPU Mismatch
E141F CPU Protocol
E1420 CPU Bus PERR
E1421 CPU Init
E1422 CPU Machine Chk
E1618 PS # Predictive
18
About Your System
Causes
Specified microprocessor is out of
acceptable temperature range and
has halted operation.
Specified processor is missing or
bad, and the system is in an
unsupported configuration.
Processors are in a configuration
unsupported by Dell.
The system BIOS has reported a
processor protocol error.
The system BIOS has reported a
processor bus parity error.
The system BIOS has reported a
processor initialization error.
The system BIOS has reported a
machine check error.
Power supply voltage is out of
acceptable range; specified power
supply is improperly installed or
faulty.
Corrective Actions
See "Troubleshooting System
Cooling Problems" on page 109.
If the problem persists, ensure
that the microprocessor heat
sinks are properly installed. See
"Troubleshooting the
Microprocessors" on page 118.
NOTE:
The LCD continues to
display this message until the
system's power cord is
disconnected and reconnected to
the AC power source, or the SEL is
cleared using either Server
Assistant or the BMC Management
Utility. See the Dell OpenManage
Baseboard Management
Controller User's Guide for
information about these utilities.
See "Troubleshooting the
Microprocessors" on page 118.
Ensure that your processors
match and conform to the type
described in the Microprocessor
Technical Specifications outlined
in your system's Getting Started
Guide.
See "Getting Help" on page 131.
See "Getting Help" on page 131.
See "Getting Help" on page 131.
See "Getting Help" on page 131.
See "Troubleshooting the Power
Supply" on page 108.