Memory Options - HPE Apollo 4200 Gen10 Plus User Manual

Installing the boot device Installing the boot device
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Select an available PCIe expansion slot that is x8 physical size and x4 electrical.
9. Remove the expansion slot cover.
Save the retaining screw, if one is present.
10. Install the boot device.
11. Install any components that were removed to access the expansion slot.
12. Install the access panel .
13. Do one of the following:
Slide the server into the rack.
Install the server into the rack.
14. Power up the server.
Deploying an operating system Deploying an operating system
15. Deploy a supported operating system to the boot device drive.
For more information, see the product QuickSpecs ( https://www.hpe.com/info/qs
After the OS installation completes, the system automatically copies the operating system to the second, mirrored drive on the boot
device.
16. Proceed with normal system setup and operation.

Memory options

Memory options
IMPORTANT: This server does not support mixing LRDIMMs and RDIMMs. Attempting to mix any IMPORTANT:
combination of these DIMMs can cause the server to halt during BIOS initialization. All memory installed
in the server must be of the same type.
https://www.hpe.com/info/qs).
HPE Apollo 4200 Gen10 Plus Server User Guide 77