Table of Contents
Advertisement
Using the PC Card Slots
When using PC cards in your NEC Versa system, please note the following:
To ensure optimal functionality when using SRAM cards in your NEC Versa, insert
!
the SRAM card in the top PC card slot.
Before using two PC cards at the same time in your NEC Versa system, you may
!
have to disable another system device to release an IRQ (system interrupt) for PC
card use.
— To disable a device (such as the serial port) in Windows 2000/98, go to Start,
Settings, Control Panel, System. In Windows 2000, select the Hardware tab,
then the Device Manager. In Windows 98, select the Device Manager tab.
— To disable a device in Windows 95/NT, reboot your system, enter the BIOS
setup and access the Peripheral Setup menu.
Inserting a PC Card
To insert a PC card, follow these steps.
Align the card so that the 68-pin connector points towards the slot and the arrow
1.
shows on the top face of the card.
2.
Slide the card into either slot. (Install Type III cards in the bottom slot, only.) A
low tone followed by a high tone lets you know that the card is fully inserted and
recognized. If you turn off the sound through the function keys or volume control,
no sound is emitted. If you insert the card before powering on the system, the tones
are emitted during bootup.
6-4 Communicating with Your NEC Versa
Advertisement
Table of Contents
