Table of Contents
Advertisement
Message
CMOS System Options
Not Set
CMOS Display Type
Mismatch
CMOS Time and Date Not
Set
Diskette Boot Failure
DMA Error
DMA#1 Error
DMA#2 Error
FDD Controller Failure
HDD Controller Failure
INTR #1 Error
INTR #2 Error
Invalid Boot Diskette
Keyboard is Locked
Unlock It
Keyboard Error
KB/interface Error
Post Error Messages
Resolution
The values stored in CMOS RAM are either corrupt or
nonexistent. Run Setup to reset the value.
The amount of memory on the system board is different
than the amount in CMOS RAM. Run Setup to reset the
value.
Run Setup to set the time and date.
The boot diskette is corrupt. It cannot be used to boot
the computer. Use another boot disk and follow the on-
screen instructions.
Error in the DMA controller. Contact your service
representative to replace the CMOS battery.
Error in the first DMA channel. Contact your service
representative.
Error in the second DMA channel. Contact your service
representative.
The BIOS cannot communicate with the floppy disk
controller. Contact your service representative to check
all appropriate connections.
The BIOS cannot communicate with the hard disk drive
controller. Contact your service representative to check
all appropriate connections.
Interrupt channel 1 failed POST. Contact your service
representative.
Interrupt channel 2 failed POST. Contact your service
representative.
The BIOS can read the diskette in the disk drive, but
cannot boot the computer. Use another boot diskette.
The keyboard lock on the computer is engaged. The
computer must be unlocked to continue.
There is a timing problem with the keyboard. Set the
Keyboard option in Setup to Not Installed to skip the
keyboard POST routines.
There is an error in the keyboard connector. Contact
your service representative.
Solving System Problems 10-5
Advertisement
Table of Contents
