Software Setup; Locking Latch During Release - NEC VERSA MEDIADOCK Service Manual

The following figure shows the mechanics of the locking latch.
Figure Section 2-10 Locking Latch During Release
6. Lift the Versa up and off the MediaDock.

SOFTWARE SETUP

The first time the MediaDock is used with the Versa, the Versa's software needs to be re-
configured to recognize the MediaDock.
Setting up the software using the following steps creates a configuration called "Medi-
aDock". When the Versa is not docked, you can specify the original Versa configuration,
called "Mobile."
Complete the following before setting up dual configurations:
n
Check that the MS-DOS level 6.0 is installed in the Versa. If the system is running
an earlier version of MS-DOS, upgrade to Version 6.0 or higher
n
Run the ACU to enable the MediaDock
n
Create a Start-Up Diskette
n
Run the MediaDock Setup utility.
NOTE: Run software setup on each hard disk
that will be used with the MediaDock.
Setup and Operation 2-9