NEC VERSA MEDIADOCK Service Manual page 82

A-2 Software Setup for Customized Disks
Modify the CONFIG.SYS file as follows.
At the DOS prompt, type the following and press
1.
2. Type the following and press
This specifies that the information under the heading is common to all configura-
tions, including Mobile and MediaDock. The file begins with DOS and memory
information, device definitions, and software execution commands. See the fol-
lowing example:
Create a Menu section as follows:
3.
n
Scroll to the end of the list. Create another label by typing in the following and
pressing
n
Under the Menu label, enter the following information to create a start-up
menu. (Press
MENUITEM=MEDIADOCK, MediaDock Configuration
MENUDEFAULT=MOBILE,15
[MEDIADOCK]
[MOBILE]
NOTE: Final configuration file contents reflect
the software and hardware loaded on or attached
to your system. Therefore, the file will probably
differ from the one shown here.
edit config.sys
Enter
[COMMON]
[COMMON]
DOS=HIGH,UMB
FILE=30
BUFFERS=10
STACKS=9,256
DEVICE=C:\DOS\HIMEM.SYS
DEVICE=C:\EMM386.EXE NOEMS X=D000-FCFF I=B000-B7FF
DEVICE=C:\DOS\SETVER.EXE
SHELL=C:\DOS\COMMAND.COM C:\DOS /P
.
Enter
[MENU]
at the end of each line.)
Enter
MENUITEM=MOBILE, Mobile Configuration
MENUITEM=MEDIADOCK, MediaDock Configuration
.
Enter
to create a new first line in the file.