Running The Acu; Running The Acu For The Versa M - NEC VERSA MEDIADOCK Service Manual

2-10 Setup and Operation

Running the ACU

Use the instructions in the section that is appropriate for the system as follows.
n Versa M System —
Go to "Running the ACU for the Versa M."
n Versa V System —
Go to "Running the ACU for the Versa V."
n All Other Versa Systems —
Go to "Running the ACU for the UltraLite Versa, Versa E, and Versa P."

Running the ACU for the Versa M

This section describes running the ACU for Versa M users. Start at step 1 or 2 depending
on the system as follows.
n
If you use your Versa M with an NEC Docking Station or Docking Station II that
has an optional IDE hard disk or a diskette drive installed, start with step 1.
n
If the user plans to operate the Versa M with a docking station that has other op-
tions but no IDE drive or diskette drive, start with step 2.
n
If the user does not plan to use the Versa M with an NEC Docking Station or
Docking Station II, start with step 2.
Proceed to the appropriate step for the Versa M.
Before docking the Versa on the MediaDock, disable the optional drive as fol-
1.
lows.
n
Power on the Versa. When the cursor changes to a blinking block, press
access the ACU.
n
From the main ACU screen, press
n
Use the down arrow to select "Load Defaults and Exit" and press
Press Enter
NOTE: Using a docking station with this type of
configuration changes the Versa ACU settings.
Therefore, you must follow this ACU setup each
time you use the MediaDock after using a dock-
ing station configured with an optional IDE hard
disk or diskette drive.
again to update your system.
X .
F1 to
.
Enter