Appendix B System Files; Config.sys - NEC VERSA MEDIADOCK Service Manual

Appendix B
System Files
This appendix provides samples of a CONFIG.SYS and an AUTOEXEC.BAT file. The files
shown reflect the contents of files after the MediaDock Setup utility is run.
The contents of system files depend on the system's software and hardware configuration.
Because of this, the samples shown here probably differ from the one on your Versa. Use
these samples as guidelines.

CONFIG.SYS

[COMMON]
DOS=HIGH,UMB
FILES=30
BUFFERS=10
STACKS=9,256
DEVICE=C:\DOS\HIMEM.SYS
DEVICE=C:\EMM386.EXE NOEMS X=D000-FCFF I=B000-B7FF
DEVICE=C:\DOS\SETVER.EXE
SHELL=C:\DOS\COMMAND.COM C:\DOS /P
rem ===================CardSoft(TM) 3.1 PCMCIA Drivers ==================
rem == If PCMCIA Cards are not used in your system, these drivers
rem == can be remarked to save system memory area.
rem ================================================================
DEVICEHIGH=C: \CARDSOFT\SSCIRRUS.EXE
DEVICEHIGH=C: \CARDSOFT\CS.EXE
DEVICEHIGH=C: \CARDSOFT\CSALLOC.EXE
rem == The next line is only needed for PCMCIA Hard drives
DEVICEHIGH=C: \CARDSOFT\ATADRV.EXE
pause
rem == The next 2 lines are only needed for SRAM cards
DEVICEHIGH=C: \CARDSOFT\MTSRAM.EXE
DEVICEHIGH=C: \CARDSOFT\MTDDRV.EXE
DEVICEHIGH=C: \CARDSOFT\CARDID.EXE
INSTALL=C: \CARDSOFT\CS_APM.EXE
[MENU]
rem =================================================================
rem The following is a menu which will allow you to choose separate