1/4-Inch Device Removal - NEC PowerMate V486 Series Service Manual

5 1/4-Inch Device Removal

Use the following procedure to remove a 5 1/4-inch device from the 5 1/4-inch device
cage.
1. Remove the top cover as previously described.
2. Unplug all signal and power cables from the device(s) in the 5 1/4-inch device
cage.
Remove the four 5 1/4-inch hard disk drive screws; two on each side.
3.
Remove the device out of the 5 1/4-inch device cage from the front of the system
4.
unit.
Figure Section 6-14 Removing a 5 1/4-Inch Device
Minitower Repair 6-15