Minitower Expansion Board Installation - NEC PowerMate V486 Series Service Manual

Minitower Expansion Board Installation

Install expansion boards into the minitower system unit as follows.
1. Remove the top cover as previously described.
2. Remove the expansion slot screw and cover. Save the expansion slot cover in the
event the expansion board is removed in the future.
Install the expansion board into an expansion slot connector. When installing a
3.
full-size expansion board, make sure that the expansion board slides into the
guide rail at the front of the system unit.
4. Reinstall the expansion slot screw to secure the expansion board.
5. Connect any expansion board cables.
6. Replace the top cover.
Figure Section 3-9 Minitower Expansion Slots
Options 3-7