Network Connectors - NEC PowerMate V486 Series Service Manual

2-10 Setup and Operation
3. Connect the right speaker cable (with the single plug) to the SPK OUT jack at the
rear of the sound board at the rear of the system unit.
Connect the 6-volt AC adapter as follows.
1. Remove any install batteries from the speakers.
2. Plug the AC adapter into the DC 6V jack on the back of the left speaker (see
Figure Section 2-8)
3. Plug the other end of the AC adapter into a properly grounded wall outlet.

Network Connectors

Some systems are configured with a network board. The network board provides three
jacks for connecting the system to the local network. The network board is a 3COM, 16-
bit, Etherlink™ network interface board. Features are as follows:
n
Hardware Plug and Play is supported.
n
Hardware configuration is software selectable (no jumpers or switches to set).
n
Includes AutoLink™ auto installation software which installs all Novell
®
ware DOS ODI client software into the operating system.
n
Provides auto select media type capability, which enables certain drivers to
automatically detect the type of media connector that connects the network board
to the network.
Figure Section 2-8 Speaker Connections
®
Net-