System Unit Cover Removal - NEC POWERMATE OFFICE 2513 Service Manual

5-2 Repair
When disassembling the system unit, follow these general rules.
n
Turn off system power and unplug the system power cable.
n
Turn off and disconnect all peripherals.
n
When handling boards or chips, touch the system unit frame to discharge static.
n
Do not disassemble parts other than those specified in the procedure.
n
All screws are Phillips-head, unless otherwise specified.
n
Label all removed connectors. Note where the connector goes and in what
position it was installed.
On completion of any reassembly, perform a power-on test (see Section 2, "Setup and
Operation"). If a fault occurs, verify that the reassembly was performed correctly.

System Unit Cover Removal

To remove and replace the system unit cover, use "Removing the System Unit Cover" in
Section 3.
CAUTION: When handling boards or chips,
ground yourself to release static.
NOTE: Unplug the power cord before
disassembling the system unit. Voltage is present
inside the system unit even after the power is off.
All voltage is removed only when the power cord
is unplugged.