Changing The Password; Processor Speed Jumper Settings - NEC POWERMATE OFFICE 2513 Service Manual

CHANGING THE PASSWORD

If a password is forgotten, use the following procedure to clear the current password and to
set a new one.
Turn off and unplug the system and any connected external options.
1.
Remove the system unit cover (see Section 3).
2.
3. Locate the Password Clear jumper block on the system board (see Figure C-1).
Remove any expansion boards blocking access to the jumper.
4. Set a jumper on the Password Clear jumper block pins.
5. Reinstall the system unit cover.
Connect system power cables and external devices.
6.
7. Turn on the system. The system boots up and clears the password.
8. Turn off the system and unplug the system and any connected peripherals.
9. Remove the system unit cover.
Figure C-2 Processor Speed Jumper Settings
WARNING: System power must be off before
removing the cover and changing a jumper
setting.
System Board Jumpers C-3