Lp Cylinder Filling - Coleman REVOLUTION II Safe Use & Care Manual

LP GAS CYLINDER REMOVAL, TRANSPORT AND STORAGE
Before disconnecting the LP gas cylinder:
1. Turn "OFF" all control knobs and the LP gas cylinder valve.
2. Turn the coupling nut counterclockwise by hand only - do not use tools to disconnect. Remove LP gas Cylinder from
inside cabinet.
3. Install the safety cap onto the LP gas cylinder valve. Always use the cap supplied with the LP gas cylinder valve.
•
Failure to use the safety cap as directed may result in serious personal injury and/or
property damage.
WARNING
When transporting and storing the cylinder, make sure it is in an upright position and not on its side.
Do not smoke around the cylinder, especially when transporting it in a vehicle.

LP CYLINDER FILLING

•
Use only licensed and experienced dealers.
•
Ensure that the dealer checks and tests the LP gas cylinder for leaks after filling.
•
LP dealer must purge new cylinder before filling.
•
Dealer should NEVER fill the LP gas cylinder more than 80% of LP gas cylinder volume. Volume of propane in cylinder
will vary by temperature.
•
Do not release liquid propane (LP) gas into the atmosphere. This is a hazardous practice.
•
To remove gas from LP gas cylinder, contact an LP dealer or call a local fire department for assistance.
WARNING
If the above instructions are not completely adhered to, it could cause a fire/explosion, resulting in death or serious injury,
or property damage.
CAUTION
A frosty regulator indicates gas overfill. Immediately close the LP gas cylinder valve and call local LP gas dealer
for assistance.
CAUTION:
A FROSTY REGULATOR INDICATES GAS OVERFILL. IMMEDIATELY CLOSE LP GAS CYLINDER VALVE AND
CALL LOCAL LP GAS DEALER FOR ASSISTANCE.
WARNING:
DO NOT SMOKE DURING LEAK TEST. DO NOT USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.
BARBECUE MUST BE LEAK TESTED OUTDOORS IN A WELL-VENTILATED AREA, AWAY FROM IGNITION SOURCES.
DURING LEAK TEST, KEEP YOUR BARBECUE AWAY FROM OPEN FLAMES OR SPARKS.
CAUTION:
IF IT IS EVIDENT THERE IS EXCESSIVE ABRASION OR WEAR, OR THE HOSE IS CUT, IT MUST BE REPLACED
PRIOR TO THE BARBECUE BEING PUT INTO OPERATION. THE REPLACEMENT HOSE ASSEMBLY SHALL BE THAT
SPECIFIED BY THE MANUFACTURER.
OUTDOOR
• An appliance is considered to be outdoors if installed with shelter no more inclusive than with walls on three sides,
but with no overhead cover; all openings must be permanently open; sliding doors, garage doors, windows, or screened
openings are not considered as permanent openings;
• An appliance is considered to be outdoors if installed with shelter no more inclusive than within a partial enclosure
that includes an overhead cover and no more than two sidewalls. The sidewalls may be parallel, as in a breezeway,
or at right angles to each other; all openings must be permanently open; sliding doors, garage doors, windows, or
screened openings are not considered as permanent openings; or
• An appliance is considered to be outdoors if installed with shelter no more inclusive than within a partial enclosure
that includes an overhead cover and three sidewalls, as long as 30% or more of the horizontal periphery of the
enclosure is permanently open. All openings must be permanently open; sliding doors, garage doors, windows, or
screened openings are not considered as permanent openings.
10