Rf Passthru; Removing The Rf Passthru Board; Installing The Rf Passthru Board - Dell LATITUDE XT2 XFR Service Manual

10. Complete the assembly by performing
4.19

RF Passthru

4.19.1

Removing the RF Passthru Board

WARNING: Before working inside your XT2 XFR, read the safety information that
shipped with your XT2 XFR. For additional safety best practices information, see the
Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
1. Follow the procedures in
2. Follow the procedures in
3. Follow the procedures in
4. Remove the two (2.5 x 5-mm) screws holding the RF Passthru board onto the bottom chassis.
5. Remove the WWAN and WLAN RF Cables from the retaining tab.
6. Lift the RF Passthru board straight up to remove.
4.19.2

Installing the RF Passthru Board

1. Connect the Black/Grey, Red and Black antenna cables from the Display assembly to the RF
Passthru board. The RF Passthru board barrel connectors are labeled for each cable.
Page 66 of 94
™
Dell Latitude™ XT2 XFR Service Manual
Installing the palm
Before Working Inside Your XT2
removing the palm rest
Removing the system board
rest.
XFR.
before continuing.
before continuing.
Version A00-01