Installing the System Board
1. Examine the system board to make sure there are nine (9) insulation pads set around the
grounding clips on the palmrest side of the system board, and one (1) on the processor side of
the system board near the docking connector.
2. Place the system board into the chassis and seat the fan cable grommet into the grommet
3. Install the screws (1 – 2.5 x 5-mm), (1- 2.5 x 8-mm with bracket) securing the system board
to the chassis.
1 Speaker connection
3 Coin-cell battery connection
Page 58 of 94
Latitude™ XT2 XFR Service Manual
2 Stylus connection
4 WiFi sniffer connection