1. Follow the procedures in
2. Follow the procedures in
3. Flip the palm rest over and remove the protective Mylar tape (covering the USB hub board
assembly), and save, as this will be replaced later during installation.
4. Disconnect the Smartcard reader cable, the Bluetooth cable and the system board cable from
the ZIF connectors on the USB Interface board.
5. Remove the 4 screws holding the USB interface board to the palm rest.
4.12
Stylus Bay
WARNING:
Before working inside your XT2 XFR, read the safety information that
shipped with your XT2 XFR. For additional safety best practices information, see the
Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
4.12.1
Removing the Stylus Bay
1. Follow the procedures in
2. Follow the procedures in
3. Disconnect the stylus bay connector from the system board.
Page 50 of 94
™
Dell
Latitude™ XT2 XFR Service Manual
Before Working Inside Your XT2
removing the palm rest
Before Working Inside Your XT2
removing the palm rest
XFR.
before continuing.
XFR.
before continuing.
Version A00-01