Installing The Rf Holder; Removing The Heatsink - Dell Latitude 14 Rugged Owner's Manual

Installing the RF Holder

1. Place the RF holder into its place on the computer.
2. Tighten the screw that secure the holder to the computer.
3. Connect the antenna cable.
4. Align the cable to the computer.
5. Install:
a. Docking Board
b. WLAN Card
c. GPS Holder
d. Bottom Cover
e. Optical Drive
f. Hard Drive
g. Battery
6. Follow the procedures in

Removing the Heatsink

1. Follow the procedures in
2. Remove:
a. Battery
b. Hard Drive
c. Optical Drive
d. Bottom Cover
e. Docking Board
f. GPU Board
g. SIM Module
3. Loosen the screws that secure the heatsink to the system board in the sequence shown [1,2,3,4].
NOTE: The screws are retained by the heatsink and should not be fully removed.
4. Lift the heatsink from the computer chassis.
20
After Working Inside Your computer
Before Working Inside Your Computer