quadient iX-1 Series Product Manual page 6

Configure your iX-1
kbhelp.quadient.com/iX-1_videos
Visit
1
Initiate configuration
Press to begin
configuring your iX-1.
2
Confirm and test connection type
Ensure your LAN cable is
connected.
Complete a connection test by
pressing .
A connection test can take up
to 4 minutes to complete.
If the server connection fails, a
message explaining the cause of
the error will appear.
Try to correct the cause and
retry. If the connection continues
to fail, unplug the system, wait 10
seconds, power up and try again.
If the connection issue persists after shut down and power up,
chat with a support specialist on Myquadient or contact us
for help at 0845 8800000
3
Confirm cartridge installation
Press to Initiate
confirmation of cartridge
installation.
Do not open the cover.
cartridge installation was
completed during assembly.
Press to continue.
For more help with your
installation, please visit:
kbhelp.quadient.com/iX-1_videos
Need help? Contact us at: www.myquadient.co.uk or call 0845 8800000
to watch the iX-1 installation video before you begin.
)
Headset remplacement
First remove headset.
Press OK when new
headset is installed.
Back OK
5
4
Test cartridge
Press to initiate the print
alignment process.
Insert an envelope into the mail
path to complete a test print or
press to skip.
5
Align the cartridge
From the pattern printed, choose
the letter where the top and bot-
tom lines are most closely aligned.
In this example, G would be
selected, but it may be a different
letter for your iX-1.
Using the up and down arrow
buttons, select the letter and
press .
Press again to align
the cartridge and complete the
installation process.
If you have trouble completing a test print, unplug the system,
wait 10 seconds, power up and try again.
If you cannot complete a test print after shut down and power
up, chat with a support specialist on Myquadient or contact us
for help at 0845 8800000.
6
Adding credit
Press the key to add
credit.
Use the down arrow button to
select add credit, then press
.
Using the numeric keypad,
enter the amount of credit to
add, then press .
The minimum amount you can
add is £10.
Your iX-1 is now ready to use!
For more information on
your franking machine, or
to access the user guide,
please visit:
www.myquadient.co.uk
p
Headset alignement
Insert an item to print a
test imprint or press Exit
to quit
Exit
Credit
1. Credit information
2. Credit
3. Audit
Credit
Credit available
£ 3000.00
Basic unit for r... £ 10.00
Amount of credit to add
£_1000.00
Myquadient.co.uk