Multifunction Digital Computer; Multifunction Indicator Functions; Trip Function; Setting The Clock - APRILIA SR 50 - USE AND MAINTENANCE BOOK Maintenance Manual

C 364
1
MULTIFUNCTION DIGITAL
COMPUTER
C 364

Multifunction indicator functions

Use the Mode button (2), on handlebar left
side, to select among various functions:
clock setting, odometer (ODO), trip meter
(TRIP), battery voltage value and trip meter
reset.
Odometer (ODO)
When the instrument panel is switched on,
the multifunction display (1) shows the
odometer function (ODO).
30
use and maintenance SR 50
C 364
1
TRIP function (TRIP)
With the odometer display (ODO), press
the Mode button (2) once to display the
function (TRIP). Hold down the Mode
button (2) for at least three seconds to
reset stored trip value.
Battery voltage
With the odometer display, press the Mode
button (2) twice to display the battery
function.
Conversion of unit of measurement -
Km/Mi
When battery voltage is displayed on
multifunction display (1), hold down the
Mode button (2) for more than ten seconds
to change the unit of measurement from
kilometres (Km) to miles (Mi). While
pressing the button, the current unit of
measurement is flashing. Should the button
be pressed for less than ten seconds, the
conversion will not take place.

Setting the clock

NOTE
For safety reasons, it is possible
to set this function when vehicle is stopped
only.
Hold down the Mode button (2) for at least
three seconds.
The column dividing hours and minutes will
start flashing.
Set the hour value, it will increase by one
unit every time you press the Mode button
(2).
Hold down the Mode button (2) again for at
least three seconds to shift to minute
setting. The indicated value will increase
by one unit every time the Mode button (2)
is pressed.
Hold down the Mode button (2) for at least
three seconds to go back to hour setting.
If no key has been touched for three
seconds, the display will automatically quit
the clock setting function.