Table of Contents
Advertisement
1
3
FRONT WHEEL
DISASSEMBLY
Read page 56 (MAINTENANCE).
NOTE
Prepare a support 8.3 in (210
mm) high and a support base 7.9 x 7.9 in
(200 x 200 mm).
◆
Place the support under the vehicle and
a spongy cloth between them, so that
the front wheel can move freely and the
vehicle cannot tip over.
WARNING
Make sure that the vehicle is stable.
60
use and maintenance SR 50
4
◆
Hold the wheel shaft (1) with an
hexagonal wrench.
◆
Loosen and remove the nut (2), collect
the washer.
Wheel shaft nut driving torque:
36.9 ftlb (50 Nm).
◆
Loosen the two screws (3) on wheel
shaft clamp.
Torque wrench setting for wheel shaft
pinch bolts: 7.4 ftlb (10 Nm).
◆
Fit the wheel shaft (1) by pushing on its
threaded end and using a rubber mallet,
if necessary.
NOTE
Check odometer fitment (4) and
spacer (7) location to be able to refit them
in the correct way.
7
2
◆
Support the front wheel and manually
slide out the wheel shaft.
◆
Remove the wheel carefully while sliding
out the brake disk from the caliper.
◆
Disengage the odometer fitment (4).
Advertisement
Table of Contents
