APRILIA SCARABEO 100 - 1999 Manual page 69

NOTE
To check the direction of the
headlight beam, specific procedures must
be adopted, in accordance with the regula-
tions in force in the country where the vehi-
cle is used.
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
N
Turn on the low beam, sit on the vehicle
and make sure that the beam projected
on the wall is slightly under the horizontal
line of the headlight (about 9/10th of the
total height).
To adjust the headlight beam:
N
Position the vehicle on the centre stand
on firm and level ground.
N
Act on the suitable screw (1) by means
of a screwdriver.
By TURNING IT CLOCKWISE, you set
the beam upwards.
By TURNING IT ANTICLOCKWISE, you
set the beam downwards.
Carefully read p. 44 (REGULAR SERV-
ICE INTERVALS CHART).
WARNING
Risk of fire.
Keep fuel and other flammable sub-
stances away from the electrical com-
ponents.
CAUTION
Before changing a bulb, move the igni-
tion switch to position "
few minutes, so that the bulb cools
down.
Change the bulb wearing clean gloves
or using a clean and dry cloth.
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage.
If you touch the bulb with bare hands,
remove any fingerprint with alcohol, in
order to avoid any damage.
DO NOT FORCE THE ELECTRIC
CABLES.
use and maintenance Scarabeo 50 - Scarabeo 100
" and wait a
69