APRILIA SCARABEO 100 - 1999 Manual page 51

REASSEMBLY
Carefully read p. 43 (MAINTENANCE).
CAUTION
While reassembling the wheel, be care-
ful not to damage the brake pipe, the
disc and the pads.
To reassemble the front wheel, proceed as
follows:
N
Spread a film of lubricating grease on the
whole length of the wheel pin (2), see
p. 80 (LUBRICANT CHART).
N
Position the wheel between the fork rods
on the support (1).
N
Position the tang (8) of the odometer
control (7) in the appropriate seat in the
wheel hub.
WARNING
Danger of injury. Do not introduce your
fingers to align the holes.
N
Move the wheel until its central hole and
the holes on the fork are aligned.
NOTE
The slot (10) in the brake
caliper (5) must be located in the lug (11)
on the inside of the left fork leg.
N
Insert the wheel between the rods, care-
fully introducing the disc in the brake cal-
iper.
N
Insert the washer (4) between the odom-
eter control (7) and the fork right rod.
N
Introduce the wheel pin (3) completely
and tighten it manually.
N
Tighten the nut (3) completely.
Wheel pin driving torque:
50 Nm (5 kgm).
N
With pulled front brake lever, press the
handlebar repeatedly, thrusting the fork
downwards.
In this way the fork rods will settle prop-
erly.
N
Tighten the screw (9) of the wheel pin
clamp.
Driving torque of the wheel pin clamp
screw: 12 Nm (1.2 kgm).
N
Make sure that the following components
are not dirty:
– tyre;
– wheel;
– brake discs.
CAUTION
After reassembly, pull the front brake le-
ver repeatedly and check the correct
functioning of the braking system.
Check the wheel centering.
Have the driving torques, centering and
balancing of the wheel checked by your
Official Dealer, in order to avoid
accidents that may be harmful for you
and/or other people.
use and maintenance Scarabeo 50 - Scarabeo 100 51